Adding Front Brake Fluid - KTM Freeride E-SX Owner's Manual

13 BRAKE SYSTEM
13.6

Adding front brake fluid

Warning
Danger of accidents Brake system failure.
–
If the brake fluid level drops below the specified marking or the specified value, this is an indication that the brake system
is leaking or that the brake linings are completely worn down. Check the brake system and do not continue riding. (Your
authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Danger of accidents Unsuitable brake fluid damages the brake system.
DOT 5 brake fluid attacks seals and brake lines. DOT 5 brake fluid is silicone-based and purple in color.
–
Do not use DOT 5 brake fluid.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the applicable regulations.
Info
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Check the front brake linings. (
Main work
–
Move the brake fluid reservoir attached to the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Add brake fluid to level
Guideline

Level
tainer rim)
C00724-10
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. (
p. 37)
p. 63)
p. 94)
p. 64)
p. 74)

.
 
with membrane .

.
(brake fluid level below con-
p. 118)
p. 94)
p. 63)
5 mm (0.2 in)
73