12
SERVICE WORK ON THE CHASSIS
12.15
Installing the start number plate (Freeride E‑SX)
12.16
Removing the front fender
12.17
Installing the front fender
Main work
–
Position the start number plate.
The holding lugs on the fender engage in the start number plate.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Position the brake line and clamp.
–
Mount and tighten screw
C00720-11
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
(Freeride E‑SX)
–
Remove the start number plate. (
(Freeride E‑XC)
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Remove the front fender.
–
Ensure that the spacers remain in place.
C00702-10
Main work
–
Position the front fender.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
C00702-10
Finishing work
(Freeride E‑SX)
–
Install the start number plate. (
(Freeride E‑XC)
–
Refit the headlight mask with the headlight. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
(Freeride E‑XC)
–
Check the headlight setting. (
.
.
p. 94)
p. 63)
p. 37)
p. 63)
p. 94)
p. 64)
p. 60)
.
.
p. 61)
p. 94)
p. 63)
p. 92)
M6
10 Nm (7.4 lbf ft)
p. 89)
M6
10 Nm (7.4 lbf ft)
p. 90)
61