Cleaning The Dust Boots Of The Fork Legs; Removing The Fork Legs - KTM Freeride E-SX Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.4

Cleaning the dust boots of the fork legs

12.5

Removing the fork legs

(Freeride E‑XC)
–
Release bleeder screws
Any excess pressure escapes from the interior of the fork.
–
Tighten the bleeder screws.
C00796-10
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Raise the motorcycle with the lift stand. (
–
Remove the fork protector. (
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can accumulate behind the dust boots. If this dirt is
not removed, the oil seals behind the dust boots can start to leak.
Warning
C00749-10
Danger of accidents Reduced braking efficiency due to oil or grease on the
brake discs.
–
–
Clean and oil the dust boots and inner fork tubes of both fork legs.
Universal oil spray (
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Install the fork protector. (
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
(Freeride E‑SX)
–
Remove the start number plate. (
(Freeride E‑XC)
–
Remove the headlight mask with the headlight. (

.
p. 94)
p. 63)
p. 37)
p. 63)
p. 94)
p. 64)
p. 53)

of both fork legs downward.
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
p. 119)
p. 53)
p. 94)
p. 63)
p. 37)
p. 63)
p. 94)
p. 64)
( p. 81)
p. 49)
p. 49)
p. 49)
p. 49)
p. 60)
p. 89)
50