17
COOLING SYSTEM
17.5
Refilling with coolant
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Position the motorcycle upright.
–
Place a suitable container under the motorcycle.
–
Remove screws
Info
The screws are located under the electric motor and can be accessed
through a recess in the motor guard.
–
C00744-10
Remove radiator cap
–
Completely drain the coolant.
–
Mount screws
Guideline
Coolant drain plug
Condition
The motor is cold.
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Ensure that the screws
Info
The screws are located under the electric motor and can be accessed
through a recess in the motor guard.
–
Position the motorcycle upright.
–
Pour coolant in up to measurement
C00744-11
Guideline
10 mm (0.39 in)
Coolant
–
Mount the radiator cap.
Finishing work
–
Remove the covering cap. (
–
Install the KTM PowerPack. (
–
Go for a short test ride.
–
Check the cooling system for leaks.
–
Check the coolant level. (
–
Remove the covering cap. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
p. 37)
p. 63)
p. 94)
p. 64)
and
.
.
and
with a new seal ring and tighten.
p. 37)
p. 63)
p. 94)
p. 64)
and
are tightened.
above the radiator fins.
0.7 l (0.7 qt.)
p. 65)
p. 94)
p. 102)
p. 65)
p. 94)
p. 63)
M6
10 Nm (7.4 lbf ft)
Coolant (
p. 118)
103