12
SERVICE WORK ON THE CHASSIS
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake
caliper
–
Position the brake line and clamp. Mount and tighten screws
C00775-10
(Freeride E‑XC)
–
Position the fork legs.
Bleeder screws
C00800-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
C00798-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake
caliper
–
Position the brake line and clamp. Mount and tighten screws
–
Connect the plug-in connector of the speedometer sensor and mount the cable
tie(s).
C00799-10
Finishing work
–
Install the front wheel.
(Freeride E‑SX)
–
Install the start number plate. (
(Freeride E‑XC)
–
Refit the headlight mask with the headlight. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
(Freeride E‑XC)
–
Check the headlight setting. (
M8
face forward.
Info
The lowest milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
The support for the brake caliper is attached to the left fork leg.
.
.
M8
(
p. 81)
p. 94)
p. 63)
p. 92)
with the spacers.
25 Nm
Loctite
(18.4 lbf ft)
M8
22 Nm
(16.2 lbf ft)
M8
18 Nm
(13.3 lbf ft)
with the spacers.
25 Nm
Loctite
(18.4 lbf ft)
p. 61)
p. 90)
52
®
243™
.
®
243™
.