Enabling Data-Group Reuse Logging; Configuring Bgp Mdt; Configuration Prerequisites - HP VSR1000 Configuration Manual

Step
Enable the RPF vector
3.
feature.
Enabling RPF vector compatibility
This feature enables the device to work with other manufacturers' products on RPF vectors for
interoperability purposes. You must enable this feature on all HPE devices on the public network.
To enable RPF vector compatibility:
Step
Enter system view.
1.
Enable RPF vector
2.
compatibility.

Enabling data-group reuse logging

For a given VPN, the number of VPN multicast streams to be switched to data-MDTs might exceed
the number of addresses in the data-group range. In this case, the VPN instance on the source-side
PE device can reuse the addresses in the address range. With data-group reuse logging enabled,
the address reuse information will be logged.
Attributed to the MD module, the group address reuse logging information has a severity level
informational. For more information about the logging information, see Network Management and
Monitoring Configuration Guide.
Perform this task on PE devices.
To enable data-group reuse logging:
Step
Enter system view.
1.
Enter MD view.
2.
Enter MD address family
3.
view.
Enable data-group reuse
4.
logging.

Configuring BGP MDT

If PIM-SSM is running on the public network, you must configure BGP MDT.

Configuration prerequisites

Before you configure BGP MDT, complete the following tasks:
•
Configure MPLS L3VPN on the public network.
Command
rpf proxy vector
Command
system-view
multicast rpf-proxy-vector
compatible
Command
system-view
multicast-domain vpn-instance
vpn-instance-name
•
Enter MD IPv4 address
family view:
address-family ipv4
•
Enter MD IPv4 address
family view:
address-family ipv6
log data-group-reuse
154
Remarks
By default, the RPF vector feature
is disabled.
Remarks
N/A
By default, RPF vector
compatibility is disabled.
Remarks
N/A
N/A
N/A
By default, data-group reuse
logging is disabled.