Olivetti d-Copia 5200MF Service Manual page 227

2KR/2KS
Removing the paper feed pulley
7. Remove two stop rings from the primary
paper feed unit.
8. Pull the paper feed pulley shaft in the direc-
tion of the arrow and remove the paper feed
pulley.
Removing the separation pulley
9. Remove the stop ring from the primary
paper feed unit.
10. Pull the separation pulley shaft in the direc-
tion of the arrow and remove the separation
pulley.
11. Replace the forwarding, paper feed and
separation pulleys.
12. Install the separation and paper feed pulleys
to the primary paper feed unit.
13. Install the forwarding pulley to the forward-
ing pulley retainer.
When refitting the forwarding pulley, orient it
correctly as shown in Figure 1-5-8.
14. Refit the forwarding pulley retainer to the pri-
mary paper feed unit.
15. Refit the primary paper feed unit.
16. When the forwarding pulley, paper feed pul-
ley, separation pulley or the primary paper
feed unit is replaced, perform maintenance
mode U901 to clear the counter value (see
page 1-3-95).
1-5-4
Paper feed
pulley shaft
Separation pulley shaft
Stop ring
Machine front
Service Manual
Stop ring
Stop ring
Paper feed pulley
Figure 1-5-6
Separation pulley
Figure 1-5-7
Machine rear
Forwarding pulley
Figure 1-5-8
Y111960-2