Olivetti d-Copia 5200MF Service Manual page 104

Maintenance
item No.
Checking messages
U245
Description
Displays a list of messages on the touch panel of the operation panel.
Purpose
To check the messages to be displayed.
Method
1. Press the start key.
2. Select the item to be displayed.
3. Displays the message one by one using cursor up/down keys. Switches the language on the touch
panel using the cursor +/- keys.
When a message number is entered with the numeric keys and then the start key is pressed, the mes-
sage corresponding the specified number is displayed.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the finisher
U246
Description
Provides various settings for the 3000-sheet document finisher, if furnished.
Purpose
Adjustment of registration stop timing in punch mode
Adjust if skewed paper conveying occurs or if the copy paper is Z-folded in punch mode.
Adjustment of paper stop timing in the punch mode
To adjust this item when the position of a punch hole is different from the specified one.
Adjustment of front/rear side registration home position of Inner tray
Provides optimization when paper jam occurs due to an inferior fitting of the Inner tray adjuster guides to
paper.
Adjusting of front and back/slanted stapling home position
Adjusts the stapling position in the staple mode if the position is not proper.
Provides adjustment of slanted stapling.
Adjustment of upper/lower side registration home position of center-folding unit
Provides optimization when paper jam occurs due to an inferior fitting of the centerfold adjuster guides to paper.
Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
Method
1. Press the start key.
2. Select the item to be set. The screen for setting each item is displayed.
Display
FINISHER 3000
BOOKLET FOLDER
FINISHER B'-IN
Setting: [FINISHER 3000]
1. Select the item to set. The screen for setting each item is displayed.
Display
PUNCH REG ADJ
PUNCH POSITION ADJ
WIDTH F HP ADJ
WIDTH R HP ADJ
STAPLE HP ADJ
TURNED STAPLE HP ADJ
Y111960-2
Description
Description
Adjustment of the 3000-sheet document finisher
Adjustment of the centerfold unit
Adjustment of the built-in finisher
Description
Adjustment of registration stop timing in punch mode
Adjustment of the paper stop timing in punch mode
Adjustment of front side registration home position
Adjustment of rear side registration home position
Adjustment of front and back stapling home position
Adjustment of slanted stapling home position
Service Manual
2KR/2KS
1-3-67