Olivetti d-Copia 5200MF Service Manual page 175

2KR/2KS
Problem
(21)
A paper jam in the
duplex section is indi-
cated during copying
(jam in duplex paper
conveying section 1).
Jam code 60
(22)
A paper jam in the
duplex section is indi-
cated during copying
(jam in duplex paper
conveying section 2).
Jam code 61
(23)
An original jams in
DP is indicated dur-
ing copying (no origi-
nal feed).
Jam code 70
(24)
An original jams in
DP is indicated dur-
ing copying (jam in
the original feed sec-
tion).
Jam code 71
(25)
An original jams in
DP is indicated dur-
ing copying (jam in
the original convey-
ing section).
Jam code 72
(26)
An original jams in
DP is indicated dur-
ing copying (jam in
the original registra-
tion section).
Jam code 73
1-4-18
Causes/check procedures
Broken feedshift switch or
duplex paper conveying
switch actuator.
Defective switch.
Broken duplex paper con-
veying switch or feed switch
1 actuator.
Defective switch.
Defective original feed
switch.
Defective original feed
motor.
Defective tray upper limit
switch.
Defective original lift motor.
Defective switch.
Defective motor.
Defective DP timing switch
1.
Defective motor.
Defective switch.
Defective motor.
Corrective measures
Check visually and replace switch.
Run maintenance item U031 and turn switch on and off manually.
Replace the switch if indication of the corresponding switch on the
touch panel is not displayed in reverse.
Feedshift switch, duplex paper conveying switch
Check visually and replace switch.
Run maintenance item U031 and turn switch on and off manually.
Replace the switch if indication of the corresponding switch on the
touch panel is not displayed in reverse.
Duplex paper conveying switch, feed switch 1
Run maintenance item U244 and turn the original feed switch on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U243 and select original feed motor on the
touch panel to be turned on and off. Check the status and remedy
if necessary.
Run maintenance item U244 and turn the tray upper limit switch
on and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U243 and select original lift motor on the
touch panel to be turned on and off. Check the status and remedy
if necessary.
Run maintenance item U244 and turn the following switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Original feed switch, original registration switch
Run maintenance item U243 and select the following motor on the
touch panel to be turned on and off. Check the status and remedy
if necessary.
Original feed motor, original conveying motor
Run maintenance item U244 and turn the DP timing switch 1 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U243 and select the following motor on the
touch panel to be turned on and off. Check the status and remedy
if necessary.
Original feed motor, original conveying motor
Run maintenance item U244 and turn the following switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Original registration switch, DP timing switch 1/2
Run maintenance item U243 and select the following motor on the
touch panel to be turned on and off. Check the status and remedy
if necessary.
Original feed motor, original conveying motor
Service Manual Y111960-2