16.1.1 SMDR (Station Message Detail Recording)
[CO Line Call]
Outgoing CO Line Call
Shows the dialed telephone number.
Digits shown are as follows:
0 through 9,
F: External Feature Access (EFA) signal
=: Host PBX Access code (® 8.1.5 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialing
–: Transferred call
If the transfer destination extension enters additional digits, those
digits will be added after "–".
Incoming CO Line Call
Shows <I> + the caller's identification name/number.
It is also possible to show the DID call information. In this case,
<D> + DID name/number is added before <I>.
[Outgoing Intercom Call]
Shows the dialed extension number followed by "EXT".
Shows the Log-in or Log-out status.
Shows the check-in or check-out status. (® 15.1.3 Room Status
Shows the status of a timed reminder, either "Start", "No
Answer", or "Answer". (® 17.1.4 Timed Reminder)
Shows the selected message. (® 13.1.11 Printing Message)
Shows calls from an external sensor as follows:
<I> S + sensor number. (® 5.1.9 External Sensor)
Shows the ring duration before the call was answered in minutes/
Shows the duration of the CO line call in hours/minutes/seconds.
Shows the account code appended to the call. (® 1.1.2 Account
Document Version 2010-11