Download  Print this page

Advertisement

[Carrier Selection Procedure Flowchart]
The numbers in parentheses indicate the corresponding items found under [Programming Procedures] on the
following pages.
An extension user accesses a CO
line and dials a telephone number.
Is the ARS mode (1) enabled?
Yes
Is the dialed number found in the
Leading Number Exception Table (2)?
No
Is the dialed number found in
the Leading Number Table (3)?
Yes
Checks the Routing Plan (4) to
determine which carrier to use.
Is the carrier found in the
appropriate time block (4)?
Yes
Is there an available
trunk group (5)?
Yes
Modifies the dialed number by
removing the digits and following
the modify commands (5).
Sends the modified number
to the CO line.
[Programming Procedures]
1.
ARS Mode
ARS is turned on by selecting under which circumstances it operates – either when an extension user
makes a call using the Idle Line Access method, or when any CO Line Access method is used (® 3.1.14 CO
Line Access). ARS can also be turned off for the entire system.
® 10.1 [8-1] System Setting—
® [320] ARS Mode
2.
Leading Number Exception Table
Once ARS is activated, store the telephone numbers that will bypass ARS in the Leading Number Exception
Table.
Note that the first few digits (leading number) of a telephone number, such as an area code or local
exchange, can also be stored, so that all calls to those areas or exchanges are exempted from ARS. Also
Document Version 2010-11
No (Normal CO Line Access)
Sends the telephone
number as dialed.
Yes
No
No
No
Because all CO
lines are busy?
Yes
CO Line Access
Sends a
Sends a
reorder tone.
busy tone.
ARS Mode
1.1.3 ARS (Automatic Route Selection)
No
Yes
(default)
Is normal
allowed?
No
Sends the telephone
number by the Idle
Line Access.
Feature Manual
17

Advertisement

Table of Contents

   Related Manuals for Panasonic KX-TDA50

This manual is also suitable for:

Kx-tda600Kx-tda100Kx-tda200

Comments to this Manuals

Symbols: 0
Latest comments: