Removing A Usb Embedded Hypervisor Flash Device - IBM System x3550 M5 Type 5463 Installation And Service Manual

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.
About this task
To remove a USB hypervisor flash device, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 126).
4. Grasp the flash device and pull to remove it from the connector.
USB embedded
hypervisor
flash device
Figure 133. USB hypervisor flash device removal
Results
If you are instructed to return the flash device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
216
IBM System x3550 M5 Type 5463: Installation and Service Guide
"Installation guidelines" on page 122.