Replacing The Security Bezel - IBM System x3550 M5 Type 5463 Installation And Service Manual

Replacing the security bezel

Use this information to replace the security bezel.
About this task
Note: Installation of the security bezel is to limit access for increased security.
To replace the security bezel, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. If necessary, turn off the server and peripheral devices and disconnect the
3. Carefully insert the two tabs on the security bezel into the slots along the right
4. Press the release latch and rotate the security bezel until the other side clicks
Figure 172. Security bezel installation
5. Use the key to lock the security bezel to the closed position.
Figure 173. Locking the security bezel
246
IBM System x3550 M5 Type 5463: Installation and Service Guide
"Installation guidelines" on page 122.
power cords and all external cables.
side of the chassis.
into place on the chassis.
Security bezel
Lockable bezel