IBM System x3550 M5 Type 5463 Installation And Service Manual page 190

Table 30. Configuration 5.
Note: Slot 1 is for standard low-profile ML2 adapter
Number of
Configura micropro
tion cessors
installed
v One ML2
slot
v Two
One
low-
profile
slots
Table 31. Configuration 6.
Note: Slot 1 is for standard low-profile ML2 adapter
Number of
Configura micropro
tion cessors
installed
v One ML2
slot
v Two
One or two
low-
profile
slots
Table 32. Configuration 7
Number of
Configura micropro
tion cessors
installed
v One
2.5-inch
hot-swap
rear hard
disk drive
One or two
kit
v One
low-
profile
slot
To install a PCI riser-card assembly, complete the following steps:
Procedure
174
IBM System x3550 M5 Type 5463: Installation and Service Guide
Configuration 5
PCI riser-card assembly connector 1
on system board
Slot 1
ML2
Configuration 6
PCI riser-card assembly connector 1
on system board
Slot 1
ML2
Configuration 7
PCI riser-card assembly connector 1
on system board
Slot 1
X
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 122.
2. Turn off the server and peripheral devices and disconnect all power cords.
PCI riser-card assembly connector 2 on system
board
Slot 2
x1/x4/x8 low-profile
PCI riser-card assembly connector 2 on system
board
Slot 2
x1/x4/x8/x16
low-profile
Note: If only one
microprocessor is
installed, slot 2 cannot
be used
PCI riser-card assembly connector 2 on system
board
Slot 2
X
Slot 3
x1/x4/x8 low-profile
Slot 3
x1/x4/x8/x16
low-profile
Slot 3
x1/x4/x8/x16
low-profile