Replacing The Eia Bracket - IBM System x3550 M5 Type 5463 Installation And Service Manual

Replacing the EIA bracket

Use this information to replace the EIA bracket.
About this task
To replace the EIA bracket, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Align the EIA bracket with the pin on the chassis; then, press the bracket onto
EIA bracket
Figure 51. EIA bracket installation
3. Install the screws to secure the EIA bracket to the chassis.
Figure 52. Screw installation
4. Slide the server back into the rack until it latches.
5. Reconnect the external cables and power cords, if necessary.
142
IBM System x3550 M5 Type 5463: Installation and Service Guide
"Installation guidelines" on page 122.
the chassis and slightly slide it leftward.
Note: Use the T8 torx wedge to install the screws.
T8 torx wrench