IBM System x3550 M5 Type 5463 Installation And Service Manual page 58

42
IBM System x3550 M5 Type 5463: Installation and Service Guide
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Power Restore Policy
Select this choice to set the mode of operation after the power lost.
- Commands on USB Interface
Select this choice to enable or disable the Ethernet over USB interface on
IMM. The default is Enable.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address, specify
whether to use the static IP address or have DHCP assign the imm2.1 IP
address, save the network changes, and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset IMM.
– Recovery
Select this choice to view or change the system recovery parameters.
- POST Attempts
Select this choice to view or change the number of attempts to POST.
v POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
- System Recovery
Select this choice to view or change system recovery settings.
v POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
v POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
v Reboot System on NMI
Select this choice to enable or disable restarting the system whenever a
nonmaskable interrupt (NMI) occurs. Enable is the default.
v Halt on Severe Error
Select this choice to enable or disable the system from booting into OS,
displaying the POST event viewer whenever a severe error was detected.
Disable is the default.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as
iSCSI.
– Drive Health
Select this choice to view the status of the controllers installed in the blade
server.