Replacing The Dvd Drive - IBM System x3550 M5 Type 5463 Installation And Service Manual

Replacing the DVD drive

Use this information to replace the DVD drive.
About this task
The following notes describe the type of drives that the server supports and other
information that you must consider when you install a drive. For a list of
supported drives, see http://www.ibm.com/systems/info/x86servers/
serverproven/compat/us.
v Locate the documentation that comes with the drive and follow those
v Make sure that you have all the cables and other equipment that are specified in
v The server supports one ultra-slim SATA DVD drive.
To install a DVD drive, complete the following steps:
Note: The DVD drive is supported on the ten 2.5-inch hot-swap or simple-swap
hard disk drive model.
Procedure
156
IBM System x3550 M5 Type 5463: Installation and Service Guide
instructions in addition to the instructions in this chapter.
the documentation that comes with the drive.
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 122.
2. Turn off the server and peripheral devices and disconnect the power cords
and all external cables.
Note: When you disconnect the power source from the server, you lose the
ability to view the LEDs because the LEDs are not lit when the power source
is removed. Before you disconnect the power source, make a note of which
LEDs are lit, including the LEDs that are lit on the operation information
panel and LEDs inside the server on the system board.
3. Remove the cover (see "Removing the cover" on page 126).
4. Remove the DVD drive filler panel if it is installed. Locate the blue release tab
on the rear of the DVD drive filler panel; then, while you press the tab, push
the DVD drive filler panel out of the drive bay.