Removing A Usb Embedded Hypervisor Flash Device - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

5. Reconnect the power cord and any cables that you removed.
6. Install the cover (see "Installing the cover" on page 174).
7. Slide the server into the rack.
8. Turn on the peripheral devices and the server.

Removing a USB embedded hypervisor flash device

To remove a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 174).
4. Grasp the flash device blue lockbar (shown in the following illustration) and slide
208
IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide
on page 167.
it toward the SAS/SATA riser-card assembly to the unlock position and remove it
from the connector.