Removing A Raid Adapter Battery Or Flash Power Module Holder - IBM System x3550 M5 Type 5463 Installation And Service Manual

Figure 46. RAID adapter battery or flash power module installation for 3.5-inch hard disk
drive server models
10. Slide the server into the rack.
11. Reconnect the power cords and all external cables, and turn on the server and
Removing a RAID adapter battery or flash power module
holder
Use this information to remove a RAID adapter battery or flash power module
holder.
About this task
To remove a RAID adapter battery or flash power module holder, complete the
following steps:
Note: The following steps only applies to 2.5-inch hard disk drive server models.
The RAID adapter battery or flash power module holder cannot be removed for
3.5-inch hard disk drive server models.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords;
138
IBM System x3550 M5 Type 5463: Installation and Service Guide
9. Reinstall the cover (see "Replacing the cover" on page 127).
peripheral devices.
"Installation guidelines" on page 122.
then, remove the cover (see "Removing the cover" on page 126).
Battery / flash power module
Holder