Removing A Usb Embedded Hypervisor Flash Device - IBM System x3650 M5 Installation And Service Manual

14. Turn on the peripheral devices and the server.

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.
About this task
To remove a USB hypervisor flash device, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the top cover (see "Removing the top cover" on page 146).
4. Remove the flash device:
Lockbar
Figure 187. USB hypervisor flash device removal
a. Unlock the retention latch on the USB connector by pushing down the blue
locking collar.
b. Grasp the flash device and pull to remove it from the connector.
5. If you are instructed to return the flash device, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
USB embedded
hypervisor
flash device
Chapter 5. Removing and replacing components
239