IBM System x3550 M5 Type 5463 Installation And Service Manual page 153

Figure 45. RAID adapter battery or flash power module installation for 2.5-inch hard disk
drive server models
Steps for installing the RAID adapter battery or flash power module for
3.5-inch hard disk drive server models.
a. Press the blue release tabs and lift the battery or power module holder
upward.
b. Align the cable connector with the slot on the holder. Place the battery or
flash power module into the holder and make sure that the holder engages
the battery or flash power module securely.
c. Connect the other end of the cable to the battery or flash power module.
d. Press the blue release tabs and lower the battery or power module holder
into the chassis.
Holder
Chapter 5. Removing and replacing components
Battery / flash power module
Retention clip
137