IBM System x3550 M5 Type 5463 Installation And Service Manual page 174

Figure 74. DVD drive retention clip installation
158
IBM System x3550 M5 Type 5463: Installation and Service Guide
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with DVD instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
6. Touch the static-protective package that contains the new DVD drive to any
unpainted metal surface on the server; then, remove the DVD drive from the
package and place it on a static-protective surface.
7. Follow the instructions that come with the drive to set any jumpers or
switches.
8. Attach the drive retention clip that you removed from the DVD drive filler
panel to the side of the new DVD drive.
Drive retention clip
Alignment pins
9. Align the DVD drive in the drive bay and slide the DVD drive into the DVD
drive bay until the DVD drive clicks into place.