Table of Contents
Advertisement
9. Slide the server into the rack.
10. Reconnect the power cords and any cables that you removed.
11. Turn on the peripheral devices and the server.
Removing the DVD drive
Use this information to remove the DVD drive.
About this task
To remove a DVD drive, complete the following steps:
Note: The DVD drive is supported on the ten 2.5-inch hot-swap or simple-swap
hard disk drive model.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 122.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the server cover (see "Removing the cover" on page 126).
4. Press and hold the release tab down as you push the drive from the rear to
slide it out of the bay.
Figure 67. DVD drive removal for 2.5-inch hard disk drive server models
Release tab
DVD drive
Chapter 5. Removing and replacing components
153
Advertisement
Table of Contents
Troubleshooting
