Replacing A Raid Adapter Battery Or Flash Power Module Holder - IBM System x3550 M5 Type 5463 Installation And Service Manual

3. Remove the RAID adapter battery or flash power module (see "Removing a
RAID adapter battery or flash power module" on page 130).
4. To remove the holder, press the blue release tab; then, slide the holder away
from the chassis.
Figure 47. RAID adapter battery or flash power module holder removal
Results
If you are instructed to return the RAID adapter battery or flash power module
holder, follow all packaging instructions, and use any packaging materials for
shipping that are supplied to you.
Replacing a RAID adapter battery or flash power module
holder
Use this information to replace a RAID adapter battery or flash power module
holder.
About this task
To install a RAID adapter battery or flash power module holder, complete the
following steps:
Note: The following steps only applies to 2.5-inch hard disk drive server models.
The RAID adapter battery or flash power module holder cannot be removed for
3.5-inch hard disk drive server models.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 122.
Chapter 5. Removing and replacing components
Blue release tab
139