Table of Contents
Advertisement
5. Press in on the blue tab on the cover-release latch and lift the cover release
latch up (the cover slides to the rear).
Figure 34. Cover removal
6. Lift the server cover off the server and set it aside.
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.
Replacing the cover
Use this information to replace the cover.
About this task
To replace the server cover, complete the following steps:
Procedure
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
Important: Before you slide the cover forward, make sure that all the tabs on
the front, rear, and side of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be very difficult to remove the cover
later.
2. Position the cover on top of the server.
3. Slide the cover toward the front of the server.
4. Make sure that the cover correctly engages all the inset tabs on the server.
5. Press down on the blue latch on the top (in the center of the front of the server)
of the cover.
Cover
Latch
Chapter 5. Removing and replacing components
127
Advertisement
Table of Contents
Troubleshooting
