IBM System x3550 M5 Type 5463 Installation And Service Manual page 191

3. Remove the cover (see "Removing the cover" on page 126).
4. Install the adapter in the new PCI riser-card assembly (see "Replacing an
adapter" on page 180).
5. Set any jumpers or switches on the adapter as directed by the adapter
manufacturer.
6. Remove the PCI filler panel, if one is present, from the rear of the server.
7. Align the PCI riser-card assembly with the PCI riser connector on the system
board; then, press down firmly until the PCI riser-card assembly is seated
correctly in the connector on the system board.
Note: When the 2.5-inch hot-swap rear hard disk drive kit is used, only the
PCI riser-card assembly with one x8 or x16 low-profile slot can be used for
connector 2 on the system board.
1U PCIe Riser 3 assembly
(1x low-profile; x8 or x16)
Figure 90. PCI riser-card assembly installation (1)
2.5-inch hot-swap rear
hard disk drive kit
Chapter 5. Removing and replacing components
175