IBM System x3550 M5 Type 5463 Installation And Service Manual page 40

System management
(dedicated)
Figure 19. Rear view connector illustration when one ML2, one full-height half length and one
low-profile PCI riser card assembly is installed in the server.
v PCI slot 1: Depending on the server configuration, insert a low-profile PCI
v PCI slot 2: Depending on the server configuration, insert a half-length,
v PCI slot 3: Insert a low-profile PCI Express into this slot.
v Ethernet connectors: Use either of these connectors to connect the server to a
v Systems-management Ethernet connector: Use this connector to connect the
v USB connectors: Connect a USB device, such as a USB mouse or keyboard to
v NMI button: Press this button to force a nonmaskable interrupt to the
v Video connector: Connect a monitor to this connector. The video connectors on
v Power cord connector: Connect the power cord to this connector.
The following illustration shows the LEDs on the rear of the server.
24
IBM System x3550 M5 Type 5463: Installation and Service Guide
Slot 2
PCI Express
Slot 1
(full-height
PCI Express
half-length)
(ML2)
USB 3.0
connectors
Express or a ML2 adapter into this slot.
full-height PCI Express or a low-profile PCI Express adapter into this slot.
network.
server to a network for full systems-management information control. This
connector is used only by the integrated management module (IMM2.1). A
dedicated management network provides additional security by physically
separating the management network traffic from the production network. You
can use the Setup utility to configure the server to use a dedicated systems
management network or a shared network.
any of these connectors.
microprocessor. It allows you to blue screen the server and take a memory
dump (use this button only when directed by the IBM service support). You
might have to use a pen or the end of a straightened paper clip to press the
button. The NMI button is in the lower left-hand corner on the rear of the
server.
the front and rear of the server can be used simultaneously.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
Note: Power supply 1 is the default/primary power supply. If power supply 1
fails, you must replace it immediately.
Ethernet Ethernet
connector 1 connector 3
Ethernet
Ethernet
connector 2
connector 4
NMI Video
USB 2.0
connector connector
Slot 3
PCI Express Power Power
(low-profile) supply 1 supply 2
Power cord
connectors