Removing The Media Cage - IBM System x3550 M5 Type 5463 Installation And Service Manual

10. Reconnect the external cables; then, reconnect the power cords and turn on
11. Start the Setup utility and reset the configuration.

Removing the media cage

Use this information to remove the media cage.
About this task
To remove the media cage, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords;
3. Remove the air baffle (see "Removing the air baffle" on page 129).
4. Disconnect the cables that may be attached to the system board. This may
222
IBM System x3550 M5 Type 5463: Installation and Service Guide
8. Reinstall the cover (see "Replacing the cover" on page 127).
9. Slide the server into the rack.
the peripheral devices and the server.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Setup utility" on page 40 for details.
"Installation guidelines" on page 122.
then, remove the cover (see "Removing the cover" on page 126).
include the DVD drive, front USB connector assembly, front video connector
assembly, operator information panel assembly, or LCD operating panel
assembly cables. After disconnecting the cables, slightly lift the release latch;
then, carefully push the media cage out of the chassis and set it aside.
Note:
v Refer to the illustration that applies to your particular server configuration
v Remember the cable routing before disconnecting the cables from the system
board.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration: