Removing The Security Bezel - IBM System x3550 M5 Type 5463 Installation And Service Manual

Figure 169. COM port bracket cable routing
10. Reconnect the power cords and any cables that you removed.
11. Turn on the peripheral devices and the server.

Removing the security bezel

Use this information to remove the security bezel.
About this task
Note: Installation of the security bezel is to limit access for increased security.
To remove the security bezel, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. If necessary, turn off the server and peripheral devices and disconnect the
3. Use the key to unlock the security bezel to the open position.
244
IBM System x3550 M5 Type 5463: Installation and Service Guide
8. Reinstall the cover (see "Replacing the cover" on page 127).
9. Slide the server into the rack.
"Installation guidelines" on page 122.
power cords and all external cables.
COM port cable connector