Removing The Eia Bracket - IBM System x3550 M5 Type 5463 Installation And Service Manual

2. Turn off the server and peripheral devices and disconnect all power cords and
3. Slide the tray until it snaps into position in the chassis.
Figure 48. RAID adapter battery or flash power module holder installation
4. Reinstall the cover (see "Replacing the cover" on page 127).
5. Slide the server into the rack.
6. Reconnect the power cords and all external cables, and turn on the server and

Removing the EIA bracket

Use this information to remove the EIA bracket.
About this task
To remove the EIA bracket, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. If necessary, turn off the server and peripheral devices and disconnect the
3. If the server has been installed in a rack, slide the server out from the rack
4. Remove the screws from the EIA bracket.
140
IBM System x3550 M5 Type 5463: Installation and Service Guide
external devices; then, remove the cover (see "Removing the cover" on page
126).
peripheral devices.
"Installation guidelines" on page 122.
power cords and all external cables.
enclosure.