Table of Contents
Advertisement
Figure 157. Operator information panel assembly removal for four 3.5-inch hot-swap or
simple-swap hard disk drive server configuration
4. Disconnect the cable from the back of the operator information panel assembly.
This step applies to all types of server configurations.
5. For the eight 2.5-inch hot-swap or simple-swap and ten 2.5-inch hot-swap hard
disk drive server configuration, remove the operator information panel
assembly from the media cage.
Note: Refer to the illustration that applies to your particular server
configuration.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:
Chapter 5. Removing and replacing components
235
Advertisement
Table of Contents
Troubleshooting
