System Information And Statistics Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1/2 Enable
1/3 Enable
1/4 Enable
1/5 Enable
1/6 Enable
(Routing)#
5-10 show xxx | section "string"
With this filtering command, the command xxx is executed, but the output is filtered so that only those
lines included within the section(s) identified by lines containing a match for the "string" and ending with
the first line that contains the default end-of-section identifier (i.e. "exit") are shown.
Example
The following provides an example of the CLI command.
(Routing)#show running-config | section "interface 0/1"
interface 0/1
no spanning-tree port mode
exit
5-11 show xxx | section "string" "string2"
With this filtering command, the command xxx is executed, but the output is filtered so that only lines
included within the section(s) identified by lines containing a match for the "string" and ending with the
first line containing a match for the "string2" are shown. If multiple sections that match the specified
string criteria are included in the base output, then all such sections are displayed.
5-12 show xxx | section "string" include "string2"
With this filtering command, the command xxx is executed, but the output is filtered so that only lines
included within the section(s) identified by lines containing a match for the "string" and a match for the
"string2" and ending with the first line containing the default end-of-section identifier (i.e. "exit") are
shown. This filter command can also include "exclude" and user-defined end-of-section identifier
parameters.

System Information and Statistics Commands

In this section, the commands used to view information about system components, features, and
configurations are described.
5-13 show arp switch
Down Disable N/A
Down Disable N/A
Down Disable N/A
Down Disable N/A
Down Disable N/A
142
N/A
N/A
N/A
N/A
N/A