Engine Oil Replacement - Yamaha FX10X Service Manual

1
1
ENGINE OIL LEVEL INSPECTION/

ENGINE OIL REPLACEMENT

NOTE:
Before checking the engine oil level, wait a few
minutes until the oil has settled.
• Start the engine, warm it up for several minutes,
and then turn it off.
• Check the engine oil level again.
NOTE:
Before checking the engine oil level, wait a few
minutes until the oil has settled.
CAUTION:
• Use only 4-stroke engine oil.
• Engine oil also lubricates the starter clutch. In
order to prevent clutch slippage, do not mix
any chemical additives with the oil or use oils
of a higher grade than "CD". In addition, do
not use oils labeled "ENERGY CONSERVING
II" or higher.
ENGINE OIL REPLACEMENT
1. Place the snowmobile on a level surface and
apply the parking brake.
2. Start the engine, warm up for several minutes,
and then turn it off.
3. Remove:
• Lower cover (left and right)
4. Place containers under the engine oil pan and
oil tank.
5. Remove:
• Bottom panel 1
6. Disconnect:
• Oil level switch coupler
7. Remove:
• Oil level gauge
8. Remove:
• Cylinder head oil filler cap 1
2-21
INSP
Refer to "COVERS" in CHAPTER 3.
Refer to "ENGINE OIL LEVEL INSPECTION".
Refer to "ENGINE OIL LEVEL INSPECTION".
ADJ