Gaskets, Oil Seals, And O-Rings; Bearings And Oil Seals - Yamaha FX10X Service Manual

Hide thumbs Also See for FX10X:

IMPORTANT INFORMATION

GASKETS, OIL SEALS, AND O-RINGS

1. All gaskets, seals, and O-rings should be replaced when an engine is

overhauled. All gasket surfaces, oil seal lips, and O-rings must be

2. Properly oil all mating parts and bearings during reassembly. Apply

grease to the oil seal lips.

LOCK WASHERS/PLATES AND COTTER PINS

All lock washers/plates 1 and cotter pins must be replaced if they are

removed. Lock tab(s) should be bent along the bolt or nut flat(s) after the

bolt or nut has been properly tightened.

Install the bearings 1 and oil seals 2 with their manufacturer marks or

numbers facing outwards. (In other words, the stamped letters must be on

the side exposed to view.) When installing oil seals, apply a light coating

of low temperature lithium-soap-based grease to the seal lips. Oil the

bearings liberally when installing.

Do not use compressed air to spin the bearings dry. This causes

damage to the surface of the bearings.

All circlips should be inspected carefully before reassembly. Always

replace piston pin clips after one use. Replace misshapen circlips. When

installing a circlip 1, make sure that the sharp edged corner 2 is posi-

tioned opposite to the thrust 3 it receives. See the sectional view.

After installing fasteners that have LOCTITE

before using the snowmobile. This will give the LOCTITE

applied, wait 24 hours

Show Quick Links