Yamaha FX10X Service Manual page 86

ENGINE OIL REPLACEMENT
13. Install:
14. Fill:
15. Inspect:
16. Inspect:
17. Inspect:
1
Inspection steps:
• Slightly loosen the oil check bolt 1.
• Start the engine and keep it idling until engine
• Check the engine oil passages, the oil filter and
• Start the engine after solving the problem(-s)
2-23
• Drain bolts
(along with the new gaskets)
Oil tank engine oil drain bolt:
16 Nm (1.6 m · kg, 11 ft · lb)
Oil pan engine oil drain bolt:
10 Nm (1.0 m · kg, 7.2 ft · lb)
• Engine oil
(with the specified amount of the recom-
mended engine oil)
Add 2.0 L (1.76 Imp qt, 2.11 US qt) of the rec-
ommended engine oil to the oil tank, and then
install and tighten the oil level gauge and the
cylinder head oil filler cap.
Quantity:
Total amount:
3.90 L (3.43 Imp qt, 4.12 US qt)
Periodic oil change:
3.00 L (2.64 Imp qt, 3.17 US qt)
With oil filter cartridge replace-
ment:
3.20 L (2.82 Imp qt, 3.38 US qt)
• Engine and oil tank
(for oil leaks)
• Engine oil level
Refer to "ENGINE OIL LEVEL INSPECTION".
• Engine oil pressure
oil starts to seep from the oil check bolt.
If no engine oil comes out after one minute, turn
the engine off so that it will not seize.
the oil pump for damage or leakage.
and check the engine oil pressure again.
Tighten the oil check bolt to specification.
Oil check bolt:
20 Nm (2.0 m · kg, 14 ft · lb)
INSP
ADJ