Yamaha FX10X Service Manual page 589

Fault code No. 16
Diagnostic code No. 01 (throttle position sensor)
Order Item/components and probable cause
1 Installed condition of throttle position
sensor.
2 Defective throttle position sensor.
Fault code No. 21
Diagnostic code No. 06 (coolant temperature sensor)
Order Item/components and probable cause
1 Connections
Coolant temperature sensor coupler
Wire harness ECU coupler
Coolant temperature sensor sub-lead
coupler
2 Open or short circuit in wire harness
and/or coolant temperature sensor sub-
lead coupler.
3 Defective coolant temperature sensor.
Fault code No. 22
Diagnostic code No. 05 (intake air temperature sensor)
Order Item/components and probable cause
1 Connections
Intake air temperature sensor coupler
Wire harness ECU coupler
2 Open or short circuit in wire harness.
3 Defective intake air temperature sensor.
FUEL INJECTION SYSTEM
Symptom Stuck throttle position sensor detected.
Check or maintenance job
Check for looseness or pinching.
Check that it is installed in the specified position.
Refer to "THROTTLE BODY".
Execute the diagnostic mode (code No. 01).
Replace if defective.
Refer to "THROTTLE BODY".
Symptom Coolant temperature sensor: open or short circuit detected.
Check or maintenance job
Check the couplers for any pins that may have
pulled out.
Check the locking condition of the couplers.
If there is a malfunction, repair it and connect the
coupler securely.
Repair or replace if there is an open or short cir-
cuit.
Between the coolant temperature sensor coupler
and ECU coupler.
Black/Blue – Black/Blue
Green/White – Green/White
Execute the diagnostic mode (code No. 06).
Replace if defective.
Refer to "SIGNAL SYSTEM" in CHAPTER 8.
Symptom Intake air temperature sensor: open or short circuit detected.
Check or maintenance job
Check the couplers for any pins that may have
pulled out.
Check the locking condition of the couplers.
If there is a malfunction, repair it and connect the
coupler securely.
Repair or replace if there is an open or short cir-
cuit.
Between the intake air temperature sensor cou-
pler and ECU coupler.
Black/Blue – Black/Blue
Brown/White – Brown/White
Execute the diagnostic mode (code No. 05).
Replace if defective.
Refer to "INTAKE AIR TEMPERATURE SEN-
SOR".
7-15
FI
Reinstatement
method
Starting the
engine, operat-
ing it at idle, and
then racing it.
Reinstatement
method
Setting the
engine stop
switch to "RUN"
and turning the
main switch on.
Reinstatement
method
Setting the
engine stop
switch to "RUN"
and turning the
main switch on.