Yamaha FX10X Service Manual page 466

AC MAGNETO ROTOR AND STARTER CLUTCH
È
É
1
4. Inspect:
• Starter clutch operation
Installation steps:
• Install the starter clutch gear onto the starter
clutch and hold the AC magneto rotor.
• When turning the starter clutch gear clockwise
È, it should turn freely, otherwise the starter
clutch is faulty and must be replaced.
• When turning the starter clutch gear counter-
clockwise É, the starter clutch and the starter
clutch gear should engage, otherwise the
starter clutch is faulty and must be replaced.
INSTALLATION
1. Install:
• Starter clutch
NOTE:
While holding the AC magneto rotor with the
sheave holder, tighten the starter clutch bolts.
Sheave holder:
90890-01701
Primary clutch holder:
YS-01880-A
2. Tighten:
• Starter clutch bolts 1
Starter clutch bolt:
12 Nm (1.2 m · kg, 8.7 ft · lb)
LOCTITE
3. Install:
• Woodruff key
• AC magneto rotor
• Washer
• AC magneto rotor bolt
NOTE:
• Clean the tapered portion of the crankshaft and
the AC magneto rotor hub.
• When installing the AC magneto rotor, make sure
the woodruff key is properly seated in the key-
way of the crankshaft.
5-42
ENG
®