Communications Parameters - Denso BHT-4000 User Manual

3.2.2 Communications Parameters

In each of System Mode, Easy Pack 4.2, and user programs written in BHT-BASIC 3.0,
you may set the communications parameters listed below.
Communications Port
Transmission Speed
Character Length
Vertical Parity
Stop Bits
RS/CS Control
In System Mode
Refer to Chapter 2, Subsection 2.4.3 Detailed Description of the Functions in System
Mode, [ 4.5 ] Setting the communications parameters and interface port.
In Easy Pack 4.2
Refer to Chapter 4, Subsection 4.3.2 Manager Menu, [ 3 ] "Set Condition" Mode.
In BHT-BASIC 3.0
To set the transmission speed, character length, and the number of stop bits, use the
OPEN "COM:" statement in BHT-BASIC 3.0.
OPEN "COM: ... "
OPEN "COM1: ..."
OPEN "COM2: ..."
Note that it is impossible to open both the optical interface port and the direct-connect
interface port concurrently.
Through the interface port opened by the OPEN "COM:" statement, the XFILE state-
ment transmits a designated file.
Optical interface or direct-connect interface
300, 600*, 1200, 2400, 4800, 9600, 19200, 38400** bps, or
High Speed***
7 or 8 bits
Odd, even, or none
1 or 2 bits
Enable or disable
* Not available in System Mode.
** Available only when the direct-connect interface port
(QM connector) has been selected.
*** Available only in Transfer Utility.
Opens the interface port selected in System Mode.
Opens the optical interface port for data transmission routing
through the CU-4000, irrespective of the setting in System Mode.
Opens the direct-connect interface port for direct data transmis-
sion, irrespective of the setting in System Mode.
80