Denso BHT-4000 User Manual page 39

(4) Press ENT key.
The BHT-4000 starts initialization operation.
Upon completion of the initialization, it displays the following message and goes off
automatically.
If the message "Report to the personnel in charge!! (S)" appears as shown on page
27 although the initialization has completed, initialize the BHT-4000 again.
If you initialize the BHT-4000 after downloading user programs or data, all of
those programs or data stored in the user area of the RAM will be lost. Download
them again if necessary.
In addition, the LCD contrast level (refer to Subsection 2.3.3), communications
conditions and other settings (refer to Section 2.4) will be restored to the default
values, so modify them if necessary . After initialization, be sure to set the calendar
clock (refer to [ 3 ]).
Chapter 2. Getting Started the BHT-4000 and System Mode
SYSTEM INITIALIZE
** Completed **
29