Interfacing With The Host Computer - Denso BHT-4000 User Manual

6.4.2 Interfacing with the Host Computer

(1) Power on the host computer and start up the MS-DOS.
(2) Turn on the power switch of the CU-4000.
(3) Make sure that the BHT-4000 is turned off, then put it on the CU-4000.
(4) Power on the BHT-4000 and start System Mode.
(5) Initiate a communications program (e.g. Transfer Utility and System Loader) in
the host computer.
(6) To transfer data stored in the BHT-4000 to the host computer, select Uploading on
the SYSTEM MENU in System Mode. To transfer data from the host computer to
the BHT-4000, select Downloading on the SYSTEM MENU. (For details, refer to
Chapter 2, Section 2.4.)
The BHT-4000 and the host computer will start communications with each other
via the CU-4000. Upon start of communications, the DATA LED of the CU-4000
will come on.
After completion of communications, the DATA LED will go off.
(7) Power off the BHT-4000, CU-4000, and the host computer.
138