Table of Contents
Advertisement
Operating the Host Computer
(1)
Load the "BHT-BASIC 3.0 System Pack" floppy disk into the drive of the host com-
puter.
(2)
Enter the following at the MS-DOS command line to initiate System Loader con-
tained in the floppy disk, and the host computer will start downloading System
Program.
X>TS3 _ _SYSPG0.SY3
Where, "
" denotes the name of the drive in which you loaded the floppy disk. The
X
"
" is the program file name of System Loader. The "
TS3
file name of System Program to be downloaded. For the options, see below.
Option List
You may specify the options listed below for downloading System Program. If
no option is specified, the defaults will apply.
Options
+B
transmissionspeed
+?
*
1
The transmission speed should be the same as specified on the BHT-4000.
2
*
The "
+B38400
terface of the BHT-4000.
option
Function
Sets the transmission speed. *
n
+B
n : 2400, 4800, 9600, 19200, or 38400*
Displays the help screen. Specifying this
option displays only the help screen without
downloading.
" is available only when you have selected the direct-connect in-
22
_ _ SYSPG0.SY3
+B19200
1
2
(bps)
(No help screen)
" is the
Default
Advertisement
Chapters
Table of Contents
