Denso BHT-4000 User Manual page 132

==píçé
=NWNÄáí==OWÄáíë
==mêçíçÅçä
==pÉêá~ä=kçK
==NWlk===OWlcc
⇓
==mêçíçÅçä
==eKm~êáíó
==NWlk===OWlcc
==mêçíçÅçä
==opL`p=`çåíêçä
==NWlk===OWlcc
Pressing 4 key on the "Set Condition"
menu displays the screen shown at left.
Select a desired stop bit length by pressing
the corresponding numerical key, and your
selection is registered and the screen auto-
matically returns to the "Set Condition"
menu.
Setting the protocol
Pressing 5 key on the "Set Condition"
menu displays the screen shown at left.
First, select whether or not the data block
serial number should be added by pressing
the corresponding numerical key.
Next, select whether or not the horizontal
parity should be added by pressing the cor-
responding numerical key.
Select whether or not the RS/CS control
should be done by pressing the correspond-
ing numerical key, and your selections above
are registered and the screen automatically
returns to the "Set Condition" menu.
122