Removing The Main Silencer; Installing The Main Silencer; Changing The Glass Fiber Yarn Filling In The Main Silencer - Husqvarna 125 XC-W 150 2017 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.29

Removing the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
12.30

Installing the main silencer

12.31

Changing the glass fiber yarn filling in the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
–
Remove screws
–
Pull the main silencer off of the manifold at the rubber sleeve
V00348-10
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screws
Guideline
Remaining screws, chassis
V00349-10
Preparatory work
–
Remove the main silencer. (

.
 .
p. 65)

.

.
M6 10 Nm (7.4 lbf ft)
65