Table of Contents
Advertisement
2 = Setting Logic
The Setting Logic option restricts a group from setting by determining which other groups must be set
before it can set. For example, group 1 may be prohibited for setting (arming) unless groups 3, 7 are
already set. The Setting Logic is individually defined for each group.
Programming Setting Logic
On selecting the Setting Logic option, group 1 is displayed. Use the A> or <B keys to move to the
required group or directly select it by pressing the required group number; press the ent key to access
the group. On selecting the group, the current Setting Logic details are displayed:
•
S below a group means that it must be set to allow the selected group to set
•
a dash (–) below the group indicates that the set status of this group is not important.
Toggle the status between S and – by pressing the number key. When the required setting logic pattern
has been defined press the ent key to accept the programming and return to the previous menu type.
Multi-group Systems
The larger GX-Series panels have 32 groups; these are displayed on the keypad in block of eight groups,
subdivided into A, B, C and D:
Use the A> or <B key to move between the group blocks; press keys 1 – 8 to toggle the Setting Logic for the
relevant groups in each block.
Setting Logic Operation
If Setting Logic has been assigned to a group, the set status of the groups must satisfy the conditions
defined in the option to permit the group to set. If the Setting Logic conditions are not satisfied, then the
group cannot set. If multiple groups are being set simultaneously, but one group is restricted due to the
programmed Setting Logic, the remainder of the groups set. The restricted group does not set; there is no
warning or indication given.
If the programmed Setting Logic results in none of the selected groups being allowed to set, a warning
message is displayed on the keypad.
This message does not appear if at least one group sets.
3 = Group Name
This option is used to assign a name of up to 12 characters to each of the groups. This name is assembled
from the character set and/or library options. On selecting the Group Name option, the name currently
assigned to group 1 is displayed. All group names default to Group X (where X is the group number).
Use the A> or <B keys to move to the required group or directly select it by pressing the required group
number; press the ent key to access the group. On selecting the group, the following details are
displayed:
Group Block
A1-8
B1-8
C1-8
D1-8
Table 6-28. Groups
Groups not set
[<],[>] to view
2 Group Name
UPPER CASE TEXT
EFG
# TO TOGGLE
UPPER CASE/
LOWER CASE/
LIBRARY
GX-Series Control Panel Installation and Setup Guide
Physical Groups
1-8
9-16
17-24
25-32
GX-083-V0
CURRENT GROUP NAME
HIJKLMNÖØOP
6-115
GX-084-V0
Advertisement
Table of Contents
