Honeywell GX-Series Installation And Setup Manual page 140

GX-Series Control Panel Installation and Setup Guide
4 = Ethernet Module
4 = Ethernet
1 = IP Address
01= Module
2 = Site Name
Config
3 = Gateway IP
4 = Network Mask
02 = Alarm 1 = Format
Reporting
2 = Primary IP
3 = Secondary IP
4 = Account No.
5 = Receiver
6 = Alarm Mon.
7 = Heartbeat
8 = Protocol
03 = Remote
1 = Access Period
Access
2 = Mode
04 = Autotest 1 = Start Time
2 = Interval
05 = Engineer Test
06 = Fail to Comm
07 = Line Fail
1 = Network
2 = Signal Path
1 = IP Address
8 = SIA Control
9 = Encrypt 1 = Alarm Report
2 = Remote Access
3 = SIA Control
4 = Alarm Mon.
10 = Backup module
1 = Off
2 = NOT USED
3 = NOT USED
4 = NOT USED
5 = Int. Telecoms
6 = Int. RS232 1
Figure 6-9. Ethernet Module Programming Structure
1 = SIA (0-4)
1 = Trigger
2 = Groups Setting
2 = Microtech
1 = IP Address
2 = Port No.
1 = IP Address
2 = Port No.
1 = Single
2 = Dual
1 = Trigger 1 = Status
2 = Groups
2 = Account No.
3 = IP Address
4 = Port No.
1 = Interval
0 = UDP
1 = TCP
1 = Off
2 = All unset
3 = Any Set
4 = Any Time
1 = Direct access
1 = Call Back IP1
2 = Mgr Authorize
2 = Call Back IP2
3 = Call Back IP3
4 = Call Back IP4
5 = Call Back IP5
0 = Off
1 = Available
1 = Primary
2 = Secondary
3 = Alarm Mon.
4 = Any
5 = All
0 = Off
1 = On
NOTE: The
0 = Off
Encrypt option
1 = On
is not used in
0 = Off
UL installations.
1 = On
0 = Off
1 = On
6-94
1 = Status
2 = Groups
1 = Account No.
2 = IP Address
3 = Port No.
1 = IP Address
2 = Port No.
1 = IP Address
2 = Port No.
1 = IP Address
2 = Port No.
1 = IP Address
2 = Port No.
1 = IP Address
2 = Port No.
GX-055-V1