Ricoh B230 Service Manual page 1036

Hide thumbs Also See for B230:
Table of Contents

Advertisement

Bit Switches
G3-2 Switch 0A [SP No. 1-106-011]
No
FUNCTION
Maximum allowable carrier
drop during image data
reception
0-1
Bit 1: 0, Bit 0: 0 = 200 (ms)
Bit 1: 0, Bit 0: 1 = 400 (ms)
Bit 1: 1, Bit 0: 0 = 800 (ms)
Bit 1: 1, Bit 0: 1 = Not used
Select cancellation of high-
speed RX if carrier signal
2
lost while receiving
0: Off
1: On
3
Not used
Maximum allowable frame
interval during image data
4
reception.
0: 5 s 1: 13 s
5
Not used
Reconstruction time for the
6
first line in receive mode
0: 6 s 1: 12 s
7
Not used
G3-2 Switch 0B - Not used (do not change the settings.)
G3-2 Switch 0C - Not used (do not change the settings.)
G3-2 Switch 0D - Not used (do not change the settings)
G3-2 Switch 0E - Not used (do not change the settings)
G3-2 Switch 0F - Not used (do not change the settings)
B786
COMMENTS
These bits set the acceptable modem carrier drop
time.
Try using a longer setting if error code 0-22 is
frequent.
This switch setting determines if high-speed
receiving ends if the carrier signal is lost when
receiving during non-ECM mode
Do not change the settings
This bit set the maximum interval between EOL
(end-of-line) signals and the maximum interval
between ECM frames from the other end.
Try using a longer setting if error code 0-21 is
frequent.
Do not change the settings.
When the sending terminal is controlled by a
computer, there may be a delay in receiving page
data after the local machine accepts set-up data
and sends CFR. This is outside the T.30
recommendation. But, if this delay occurs, set this
bit to 1 to give the sending machine more time to
send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line should
come within 5 s of CFR.
Do not change the settings.
86
SM

Advertisement

Table of Contents
loading

This manual is also suitable for:

B237

Table of Contents