Ricoh B230 Service Manual page 1006

Bit Switches
Destination telephone
2 number display limitation
0: OFF, 1: ON
Operation selection without
PIN code registered
3 0: Transmission interrupted
1: No interrupted
transmission
4-7 Not used
System Switch 1E [SP No. 1-101-031]
No FUNCTION
Communication after the
Journal data storage area has
0 become full
0: Impossible
1: Possible
Action when the SAF memory
has become full during
1 scanning
0: The current page is erased.
1: The entire file is erased.
RTI/CSI display priority
2
0: RTI 1: CSI
File No. printing
3 0: Enabled
1: Disabled
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
4
yet programmed
0: All fax reception is disabled
1: Faxes can be received if
B786
When "1" is selected, the destination telephone
number display is limited and redial is disabled.
0: When "0" is selected without PIN code
registration, transmission is interrupted and an alert
message shows on the LCD.
Do not change these settings.
COMMENTS
0: When this switch is on and the journal history
becomes full, the next report prints. If the journal
history is not deleted, the next transmission
cannot be received. This prevents overwriting
communication records before the machine can
print them.
1: If the buffer memory of the communication
records for the Journal is full, fax communications
are still possible. But the machine will overwrite
the oldest communication records.
Note: This setting is effective only when Automatic
Journal printout is enabled but the machine
cannot print the report (e.g., no paper).
0: If the SAF memory becomes full during
scanning, the successfully scanned pages are
transmitted.
1: If the SAF memory becomes full during
scanning, the file is erased and no pages are
transmitted.
This bit switch is ignored for parallel memory
transmission.
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
1: File numbers are not printed on any reports.
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax
messages.
If the customer wishes to receive messages from
any sender that includes an RTI or CSI, and to
56 SM