Ricoh B230 Service Manual page 1019

Acceptable total error line ratio
1
0: 5% 1: 10%
Treatment of pages received
with errors during G3
reception
2
0: Deleted from memory
without printing
1: Printed
Hang-up decision when a
negative code (RTN or PIN) is
3 received during G3 immediate
transmission
0: No hang-up, 1: Hang-up
4-7 Not used
Communication Switch 03 [SP No. 1-104-004]
No FUNCTION
Maximum number of page
0-7 retransmissions in a G3
memory transmission
Communication Switch 04 - Not used (do not change the settings)
Communication Switch 05 - Not used (do not change the settings)
Communication Switch 06 - Not used (do not change the settings)
Communication Switch 07 - Not used (do not change the settings)
Communication Switch 08 - Not used (do not change the settings)
Communication Switch 09 [SP No. 1-104-010]
No FUNCTION
0-7 IP-Fax dial interval setting
Communication Switch 0A [SP No. 1-104-011]
SM
If the error line ratio for a page exceeds the
acceptable ratio, RTN will be sent to the other
end.
0: Pages received with errors are not printed.
0: The next page will be sent even if RTN or PIN
is received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if
ECM is being used.
Do not change the settings.
COMMENTS
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
COMMENTS
Adjusts the interval of the I-fax dialing.
The interval of I-fax dialing is calculated by
following formula.
[Interval time = specified value with this switch x
0.2 msec]
69
Bit Switches
B786