Ricoh B051 Service Manual page 1008

Rev. 06/2003
Mode No.
2
(Class 1, 2, and 3)
⇒
944 OPC Lubrication: High Coverage
1 Setting
2 Image Coverage–1
3 Image Coverage–2
4 Sheets–1
5 Sheets–2
950 Start Registration Adjustment
1 Start Registration
Adjustment 1–K
2 Start Registration
Adjustment 1–M
3 Start Registration
Adjustment 1–C
4 Start Registration
Adjustment 1–Y
5 Start Registration
Adjustment 2–K
SM
CÓPIA NÃO CONTROLADA
Enables/disables OPC lubrication after a certain amount
of images are printed. The lubrication timing depends on
SP2-944-2 to -5.
• 0: Disables 1: Enables
When high coverage images are continuously printed,
cleaning of the OPC may not be enough. To correct this,
OPC lubrication is carried out during printing (lubrication
time: around 34 seconds).
Specifies standard average coverage condition 1.
[50 ~ 800 / 300 / 10 units/step]
OPC lubrication is executed under the following
conditions.
• After the previous OPC lubrication, the number of
output pages reaches the value specified with SP2-
944-4.
• The average coverage of the outputs after the
previous OPC lubrication exceeds standard average
coverage condition 1.
Specifies standard average coverage condition 2.
[50 ~ 800 / 200 / 10 units/step]
OPC lubrication is executed under the following
conditions.
• After the previous OPC lubrication, the number of
output pages reaches the value specified with SP2-
944-5.
•
The average coverage of the outputs after the
previous OPC lubrication exceeds standard average
coverage condition 2.
[10 ~ 80 / 20 / 1 sheet/step]
[10 ~ 80 / 40 / 1 sheet/step]
Color registration adjustment: Adjusts the start timing of
imaging for each color.
[–3 ~ 3 / 0 / 1 line/step] DFU
2 lines = 0.047566 ms (about 85 µm)
• +: Delays the start timing.
• –: Advances the start timing.
• The start timing is adjusted only in plain paper mode,
and when one of the following conditions is satisfied:
1) Between the two images on the transfer belt (when
two images are developed on the OPC at the
same time (
2) B4 SEF or larger (multi-print job)
[–3 ~ 3 / –1 / 1 line/step]
[–3 ~ 3 / 0 / 1 line/step]
[–3 ~ 3 / 0 / 1 line/step]
[–3 ~ 3 / 0 / 1 line/step]
5-19
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Function / [ Setting ]
[0 ~ 1 / 1 / 1 /step]
6.2))
B051/B052