Firmware History for B051/B052
Corrects the following:
•
Duplex face settings (front/rear) not applied correctly when specified with PCL
commands.
•
Binding position not applied correctly when specified with PCL commands
•
CAD print files:
- Modified so that the "null" character is ignored when it is included in HP/GL2 data to
increase speed
- The status flag for the bold selection command is refreshed when it is selected for
HP/GL2 data
•
The following image problem may occur in Black Over Print mode.
1. The image is blank around Bk figures
2. Gradation images will not print
•
Supports the Card Save function.
NOTE:
To enable this function, set Printer SP1-1 Bit SW1, bit 4 to "1".
•
Selecting HDD font or DIMM font may reduce available memory
•
Supports SAP Barcode & OCR printing.
•
PCL command "<ESC>&l11G" (select MailBoxBin8 as output tray) does not work
correctly.
Corrects the following:
•
Supports KS/KSSM Emulation (for Korea).
Corrects the following:
•
Merged PCL job cannot print.
CÓPIA NÃO CONTROLADA
SYMPTOM CORRECTED
CÓPIA NÃO CONTROLADA
FIRMWARE
VERSION
2.00
2.01
2.01.2
Page 31 of 37